Ermengardi Snowmobile May 29th, 2018 - 10:51:22
Check out the porcelain part of the spark plug. Does it appear to have changed color? The white porcelain is the insulator of the spark plug. If the porcelain has turned beige or a light tan color then it is still in good working order. If the spark plug is very white you could have an air leak. If it has changed to other colors then you have a problem with the engine. Is there plenty of coolant? If the coolant levels are low put fresh coolant into the snowmobile following the owners manual guidelines.A recommended coolant/antifreeze is ethylene glycol (the green kind) to resist freezing.
Loose head nuts can cause a loss in compression. Replace any worn or damaged gaskets. Are there blockages in the fuel line? The next step is to check your fuel line for blockages. Remove the shroud that covers the engine. The fuel line runs from the tank to the engine and is usually clear so blockages will be easy to see. Blockages are caused by improper storage of your snowmobile. If you find a blockage remove the fuel line clean out the blockage and return it to its original position. If it is damaged replace it. What do the spark plugs look like? You should check the spark plugs in the snowmobile. Clean away carbon or other corrosion with a wire brush.
If A Driver Is Responsible If you are involved in a snowmobile accident with another snowmobiler you will want to call a law enforcement officer or patrol officers. A law enforcement officer can write an official accident report that will determine the speeds of the snowmobiles and if either driver was negligent or impaired at the time of the accident. Speed and alcohol or drug impairment are two major factors in snowmobile accidents and their documentation can help you gain the compensation you deserve. If The Snowmobile was Responsible Sometimes accidents occur because a snowmobile was not properly designed.
The owners manual will provide a diagram of the snowmobiles engine and where to find all of its components. Is the engine stop switch pushed in the off position? The "Engine stop" switch is located on the snowmobiles control panel. Double check to make sure that the switch is not stuck in the off position.The "Engine stop" switch (if pushed down) will prevent the motor from starting. Is there gas left in the fuel tank since last winter? Next you must investigate the fuel tank. Gasoline can degrade over time. That can lead to a number of problems- hard starting rough running or no starting at all.